Customer Self-Service Portal
            Knowledge Base Site24x7 Knowledge Base Server Monitoring Windows Server Monitoring

            Troubleshooting steps if bulk install during installation of Windows agent fails

            You can now bulk install during the installation of the Windows agent itself. In case the bulk installation fails, it might be due to one of the following reasons:

            Error Message/Issue
            Troubleshooting Tip
            Network Connectivity Failure
            Make sure all the machines in the domain are connected to the network
            Incorrect Username and Password
            Ensure you have entered the correct credentials of your Active Directory account
            Proxy error
            Ensure proxy configuration is right. The Windows agent uses the proxy details of the server where it is installed. So make sure that the proxy configuration for the both the servers in the domain is correct
            Accessibility error
            Remote issues
            Confirm if the target server can be taken remote from the server where the Windows agent is installed
            Agent installation error
            Check if the machine in the domain already has the agent installed in it.
            Error message "Couldn't connect to \\servername\ADMIN$. The network path was not found"
            Go to Advanced Sharing Settings > Domain. Turn on Network Discovery and File and Printer Sharing. Refer screenshot below.




            Updated: 28 May 2018 06:30 PM
            Helpful?  
            Help us to make this article better
            0 1