Associate a supported monitor type to an On-Premise Poller

• Related Articles

• Prerequisites for installing the On-Premise Poller

  To monitor your internal network and resources behind a firewall, you need to install the On-Premise Poller within your network. You can install the On-Premise Poller on physical or virtual machines. System requirements: The machine on which the ...

• Prerequisites for an On-Premise Poller to be assigned as a standby for another On-Premise Poller

  The On-Premise Poller that is being associated as standby On-Premise Poller must not be in a down or suspended state. The On-Premise Poller version should be 4.3.0 or above. The On-Premise Poller should not have any monitor associated with it. The ...

• Amount of bandwidth consumed by an On-Premise Poller

  The On-Premise Poller software collects metrics from the internal network and pushes the same to the Site24x7 central server. Check the table below for the bandwidth consumed for each monitor type: Monitor Type Bandwidth Consumed Poll Interval 10 NCM ...

• Checking the accessibility of Site24x7 server from the On-Premise Poller

  Once you've installed the On-Premise Poller, perform the following actions to check if the On-Premise Poller can connect to Site24x7 servers. Ensure to allow access to the necessary ports. Note: The domain referenced in this page applies to the ...

• How to install packages to support Web Transaction (Browser) monitor in Linux On-Premise Poller

  To support Web Transaction (Browser) monitor on an On-Premise Poller, you can execute the following command in the terminal to install packages in CentOS 7.0 to 7.8 or in RHEL 7.x. Note: The Installation is supported only on 64-bit OS. Execute the ...