Recently the Add a network device has changed

One of the useful features  of the old process (network discovery)  was that you could add a single network device  (by specifying the same start and end ip address)

The reason why this was useful was that part of the discovery, the resolved network device name  would appear in the display name.

If this didnt occur then this would point to a network configuration issue which could then be investigated.

This feature no longer is available for adding a single device. You are now forced to enter a device name rather than let it detect it.

If you specify a range and perform a discovery then there is no issue, devices are added with the resolved display name.

would it be possible to remove the limitation of not being able to specifiy the same address for start and end network discoveries.